[GET] CyberLink PowerDirector Ultimate Suite v13 140811-01 Multilingual - Cracked

Discussion in 'Member Downloads' started by inquisitor, Feb 18, 2015.

Thread Status:
Not open for further replies.
  1. Walker

    Walker Well-Known Member

    Joined:
    Aug 4, 2012
    Messages:
    187
    Likes Received:
    480
    Trophy Points:
    63
    Immaculate instructions as always but I'm having problems, all good up to

    At that point the pop up window is an activation window, that fails and the programme closes.

    Not sure where to take it from here.

    Walker
     
    #21
    inquisitor likes this.
  2. inquisitor

    inquisitor SUPER VIP LIFETIME Jr. VIP

    Joined:
    Oct 25, 2010
    Messages:
    3,975
    Likes Received:
    40,768
    Trophy Points:
    113
    Gender:
    Male
    Occupation:
    Prestidigitator
    Location:
    Cybercity
    I'm sorry; I misplaced a step in the new installation instructions that were in the old instructions (I was supposed to move them further down, what happened was I cut them out and forgot to paste them back in.. :()

    Here it is..

    After you install the program, do as follows..

    On the keygen, click on...

    'Add Online Activation' then click 'Remove Online Activation'.

    In the 'Activation Code:' window you will see 'Online Activation Removed!'.

    then open the program up and import an .mp4 video

    then carry out the remaining installation instructions.

    Doing that will then allow the program to open up.. :D

    I'll re-upload these new instructions.

    Regards.. :)
     
    #22
    Walker likes this.
  3. inquisitor

    inquisitor SUPER VIP LIFETIME Jr. VIP

    Joined:
    Oct 25, 2010
    Messages:
    3,975
    Likes Received:
    40,768
    Trophy Points:
    113
    Gender:
    Male
    Occupation:
    Prestidigitator
    Location:
    Cybercity
    New instruction added to the Installation Instructions...

    I forgot to add a key step about using the keygen..!!

    So re-download the Installation Instructions from the OP above..


    Regards.. :)
     
    #23
    ted12, Walker and lyallo like this.
  4. Walker

    Walker Well-Known Member

    Joined:
    Aug 4, 2012
    Messages:
    187
    Likes Received:
    480
    Trophy Points:
    63
    Install went very smoothly with new instructions and all working perfectly.

    Quick question for clarification, once phase 3 has been completed am I correct in thinking the last action is to follow phase 2 instructions to disable upgrades?

    Walker
     
    #24
    inquisitor likes this.
  5. inquisitor

    inquisitor SUPER VIP LIFETIME Jr. VIP

    Joined:
    Oct 25, 2010
    Messages:
    3,975
    Likes Received:
    40,768
    Trophy Points:
    113
    Gender:
    Male
    Occupation:
    Prestidigitator
    Location:
    Cybercity
    Yep.. well actually, after you upgrade you open that upgrade tool and click 'Restore'.

    I thought there was no requirement to mention this part as it would be obvious; but, then again, the problem with anything being offered in BHT is that if you don't state the obvious then it instantly becomes an issue that gets raised over and over in the threads, but I can't be @r$3d with rewriting and uploading the instructions yet again just to state that point.. :(

    Regards.. :)
     
    #25
    blackhatheaven and Walker like this.
Thread Status:
Not open for further replies.

Share This Page